Call us on: 01234 217417

Spare Parts For SIP 12" 01486 Bandsaws

  • Drive Belts
  • Wheel Tires
  • Table Inserts
  • Wheel Bearings

Spare parts for the SIP 12" 01486 bandsaws.

These consumable parts may also fit other models so if you are unsure feel free to contact us. Tel: 01234 217417 / 359808 E-mail: sales@bedfordsaw.co.uk

Wheel Bearing For - SIP 12" 01486 Bandsaws

Picture of Wheel Bearing For - SIP 12" 01486 Bandsaws
£4.58 ex VAT
  • High Quality UNM
  • 40mm OD
  • ZZ Double Shield
  • Deep Groove Ball Bearings

Replacement bearing for the center of the aluminium wheels that the blade runs on.

Note: Each wheel has 2x bearings.

Sold individually.

Motor Starter Capacitor For - SIP 12" 01486 Bandsaws

Picture of Motor Starter Capacitor For - SIP 12" 01486 Bandsaws
£10.42 ex VAT
  • Direct Replacement
  • 450VAC
  • 15UF

Replacement 15UF leaded motor starter capacitor for the for SIP 12" 01486 Bandsaws.

If your bandsaw makes a humming sound and doesn't work when you press the start button, this part may be the cause.

This unit is on the side of the motor and connects with two wires.

Table Insert For - SIP 12" 01486 Bandsaws

Picture of Table Insert For - SIP 12" 01486 Bandsaws
£6.67 ex VAT

Replacement insert for the center of your bandsaws table.

Round plastic with slot for the blade to run through and holes to allow dust to escape.

Tyre/Tire For - SIP 12" 01486 Bandsaws

Picture of Tyre/Tire For - SIP 12" 01486 Bandsaws
£12.08 ex VAT

Replacement tyre for SIP 12" 01486 Bandsaws. This stretches over the aluminium wheel that the blade runs on.

The original tyres perish over time or become damaged.

These new tyres are a shrink fit and will need to be stretched onto the wheels.

Supplied With Replacement Circlip

Note: Wheel NOT Included

* Sold individually

Drive Belt For - SIP 12" 01486 Bandsaws

Picture of Drive Belt For - SIP 12" 01486 Bandsaws
£14.99 ex VAT
  • Replaces Factory Original
  • Belt Runs From Motor To Bottom Wheel
  • Supplied With Replacement Circlip

High quality poly v drive belt to replace the original belt running from the motor to the bottom wheel on SIP 12" 01486 Bandsaws.

Instructions: Take the tension off and remove the blade. Using a pair of circlip pliers remove the circlip on the bottom wheel. There is nothing else holding the wheel in place, so it should simply slide off the shaft. Slacken the motor only which will remove tension from the belt. Replace the belt and retension by sliding the motor back into place. Do not over tension. Replace wheel, circlip and blade.